McqMate

Q. |
## Number of rivets required in a joint, is |

A. | load/shear strength of a rivet |

B. | load/bearing strength of a rivet |

C. | load/tearing strength of a rivet |

D. | load/rivet value |

Answer» D. load/rivet value |

1.8k

0

Do you find this helpful?

4

View all MCQs in

Design of Steel StructuresNo comments yet

- If N is the number of rivets in the joint, the strength of a riveted joint against shearing of rivets, is given by
- As compared to field rivets, the shop rivets are
- In a truss girder of a bridge, a diagonal consists of mild steel flat 4001.S.F. and carries a pull of 80 tonnes. If the gross-diameter of the rivet is 26 mm, the number of rivets required in the splice, is
- If the pitch is 6 cm and rivet value is 4 tonnes, the number of rivets required for a riveted connection carrying an eccentric load of 15 tonnes at a distance of 30 cm from the centre line, is
- Strengths of a rivet in single shearing, in bearing and in tearing are 3425 kg, 4575 kg and 5025 kg respectively. If the load in the member is 35 tonnes, the number of rivets required, is
- In a truss girder of a bridge, a diagonal consists of mild steel flat 4001.S.F. and carries a pull of 80 tonnes. If the gross-diameter of the rivet is 26 mm, the number of rivets required in the splice, is
- If the pitch is 6 cm and rivet value is 4 tonnes, the number of rivets required for a riveted connection carrying an eccentric load of 15 tonnes at a distance of 30 cm from the centre line, is
- Strengths of a rivet in single shearing, in bearing and in tearing are 3425 kg, 4575 kg and 5025 kg respectively. If the load in the member is 35 tonnes, the number of rivets required, is
- If p and d are pitch and gross diameter of rivets, the efficiency ( ) of the riveted joint, is given by
- IS : 800 - 1971 recommends that in a splice plate the number of rivets carrying calculated shear stress through a packing greater than 6 mm thick, is to be increased by 2.5% for every