- Civil Engineering
- Design of Steel Structures
- The maximum axial load which is just suf...

Q. |
## The maximum axial load which is just sufficient to keep a column in a small deflected shape, is called |

A. | crippling load |

B. | buckling load |

C. | critical load |

D. | all the above |

Answer» D. all the above |

View all MCQs in:
Design of Steel Structures

- The maximum axial load which is just sufficient to keep a column in a small deflected shape, is called
- As per IS: 800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor (i) Dead load 1.7 (ii) Dead Load + imposed load 1.7 (iii) Dead load + load due to wind or 1.3 seismic forces (iv) Dead load + imposed load + load 1.7 due to wind or seismic forces Of these statements
- To keep the intensity of bearing pressure between the column base and concrete, compressive throughout the length of the column base, the ratio of the moment M to axial load P should be
- The equivalent axial tensile load Pe, which produces an average axial tensile stress in the section equivalent to the combined stress due to axial tension P and bending M, at the extreme fibre of the section, is given by (where Z is the section modulus of the section).
- To keep the intensity of bearing pressure between the column base and concrete compressive and to vary from zero to 2P/BL, the ratio of the moment M to the axial load P should be
- To keep the intensity of bearing pressure between the column base and concrete compressive and to vary from zero to 2P/BL, the ratio of the moment M to the axial load P should be
- Battening is preferable when the (i) Column carries axial load only (ii) Space between the two main components is not very large (iii) Column is eccentrically loaded The correct answer is
- In a gusseted base, when the end of the column is machined for complete bearing on the base plate, then the axial load is assumed to be transferred to base plate
- In a gusseted base, when the end of the column is machined for complete bearing on the base plate, then the axial load is assumed to be transferred to base plate
- The equivalent axial load may be defined as the load which produces a stress equal to

Login to Continue

It will take less than 2 minutes

Report MCQ