McqMate
These multiple-choice questions (MCQs) are designed to enhance your knowledge and understanding in the following areas: Electrical Engineering .
| 51. |
The line insulation is the insulation level of the station equipment. |
| A. | less than |
| B. | same as |
| C. | more than |
| D. | not directly related with |
| Answer» D. not directly related with | |
| 52. |
The interaction between a transmission line and communication line is minimized by |
| A. | transposing transmission as well as communication lines |
| B. | increasing the height of the trans-mission line tower |
| C. | increasing the distance between the two lines |
| D. | all of the above |
| Answer» D. all of the above | |
| 53. |
When a wave propagates on a transmission line, it suffers reflection several times at |
| A. | tapping |
| B. | load end |
| C. | sending end |
| D. | sending and other end |
| Answer» D. sending and other end | |
| 54. |
Which of the following statements is incorrect? |
| A. | Station batteries are used to operate relay only |
| B. | The lightning arresters are basically surge diverters |
| C. | An impedance relay has maximum fault current when fault occurs near the relay |
| D. | A high speed relay has an operation of 1 to 2 cycles |
| Answer» A. Station batteries are used to operate relay only | |
| 55. |
Discrimination between main and back up protection is provided by the use of relays which are |
| A. | fact |
| B. | sensitive |
| C. | slow |
| D. | none of the above |
| Answer» C. slow | |
| 56. |
Induction cup relay is operated due to changes in |
| A. | current |
| B. | voltage |
| C. | impedance |
| D. | all of the above |
| Answer» D. all of the above | |
| 57. |
A.C. network analyser is used to solve problems of |
| A. | load flow |
| B. | load flow and short-circuit |
| C. | load flow and stability |
| D. | load flow, short-circuit and stability |
| Answer» D. load flow, short-circuit and stability | |
| 58. |
Which of the following statements is incorrect ? |
| A. | Lightning arrestors are used before the switchgear |
| B. | Shunt reactors are used as compensation reactors |
| C. | The peak short current is (1.8 xV2) times the A.C. component |
| D. | The MVA at fault is equal to base MVA divided by per unit equivalent fault reactance |
| Answer» A. Lightning arrestors are used before the switchgear | |
| 59. |
Short-circuit currents are due to |
| A. | single phase to ground faults |
| B. | phase to phase faults |
| C. | two phase to ground faults |
| D. | any of these |
| Answer» D. any of these | |
| 60. |
To reduce short circuit fault currents are used. |
| A. | reactors |
| B. | resistors |
| C. | capacitors |
| D. | none of the above |
| Answer» A. reactors | |
| 61. |
Bus coupler is very essential in arrangement |
| A. | single bus |
| B. | double bus, double breaker |
| C. | main and transfer bus |
| D. | all of the above |
| Answer» C. main and transfer bus | |
| 62. |
For cost and safety, the outdoor substations are installed for voltages above |
| A. | 11 kV |
| B. | 33 kV |
| C. | 60kV |
| D. | 110kV |
| Answer» B. 33 kV | |
| 63. |
The short circuit in any winding of the transformer is the result of |
| A. | mechanical vibration |
| B. | insulation failure |
| C. | loose connection |
| D. | impulse voltage |
| Answer» D. impulse voltage | |
| 64. |
relays are used for phase faults on long line. |
| A. | Impedance |
| B. | Reactance |
| C. | Either of the above |
| D. | None of the above |
| Answer» A. Impedance | |
| 65. |
For which of the following protection from negative sequence currents is provided? |
| A. | Generators |
| B. | Motors |
| C. | Transmission line |
| D. | Tr |
| Answer» A. Generators | |
| 66. |
relay is preferred for phase fault on short transmission line. |
| A. | Induction type |
| B. | Reactance |
| C. | Impedance |
| D. | None of the above |
| Answer» B. Reactance | |
| 67. |
Distance relays are generally |
| A. | split-phase relays |
| B. | reactance relays |
| C. | impedance relays |
| D. | none of the above |
| Answer» D. none of the above | |
| 68. |
For which of the following ratings of the transformer differential protection is recommended ? |
| A. | above 30 kVA. |
| B. | equal to and above 5 MVA |
| C. | equal to and above 25 MVA |
| D. | none of the above |
| Answer» B. equal to and above 5 MVA | |
| 69. |
A _______ is used to measure the stator % winding temperature of the generator. |
| A. | thermocouple |
| B. | pyrometer |
| C. | resistance thermometer |
| D. | thermometer |
| Answer» C. resistance thermometer | |
| 70. |
The under voltage relay can be used for |
| A. | generators |
| B. | busbars |
| C. | transformers |
| D. | all of the above |
| Answer» D. all of the above | |
| 71. |
The relay with inverse time characteristic will operate within |
| A. | 1.5 sec |
| B. | 5 to 10 sec |
| C. | 5 to 20 sec |
| D. | 20 to 30 sec |
| Answer» B. 5 to 10 sec | |
| 72. |
The single phasing relays are used for the protection of |
| A. | single phase motors only |
| B. | two phase motors only |
| C. | two single phase motors running in parallel |
| D. | three phase motors |
| Answer» D. three phase motors | |
| 73. |
Which of the following devices will receive voltage surge first travelling on the transmission line ? |
| A. | Lightning arresters |
| B. | Relays |
| C. | Step-down transformer |
| D. | Switchgear |
| Answer» A. Lightning arresters | |
| 74. |
Which of the following parameter can be neglected for a short line ? |
| A. | Inductance |
| B. | Capacitance |
| C. | Resistance |
| D. | Reactance |
| Answer» B. Capacitance | |
| 75. |
Series reactors should have |
| A. | low resistance |
| B. | high resistance |
| C. | low impedance |
| D. | high impedance |
| Answer» A. low resistance | |
| 76. |
Which of the following circuit breakers has high reliability and minimum maintenance ? |
| A. | Air blast circuit breakers |
| B. | Circuit breaker with SF6 gas |
| C. | Vacuum circuit breakers |
| D. | Oil circuit breakers |
| Answer» B. Circuit breaker with SF6 gas | |
| 77. |
Arc in a circuit breaker is interrupted at |
| A. | zero current |
| B. | maximum current |
| C. | minimum voltage |
| D. | maximum voltage |
| Answer» A. zero current | |
| 78. |
transmission line has reflection coefficient as one. |
| A. | Open circuit |
| B. | Short-circuit |
| C. | Long |
| D. | None of the above |
| Answer» A. Open circuit | |
| 79. |
What will be the reflection co-efficient of the wave of load connected to transmission line if surge impedance of the line is equal to load ? |
| A. | Zero |
| B. | Unity |
| C. | Infinity |
| D. | None of the above |
| Answer» A. Zero | |
| 80. |
The inverse definite mean time relays are used for over current and earth fault protection of transformer against |
| A. | heavy loads |
| B. | internal short-circuits |
| C. | external short-circuits |
| D. | all of the above |
| Answer» B. internal short-circuits | |
| 81. |
Over voltage protection is recommended for |
| A. | hydro-electric generators |
| B. | steam turbine generators |
| C. | gas turbine generators |
| D. | all of the above |
| Answer» D. all of the above | |
| 82. |
Air blast circuit breakers for 400 kV power system are designed to operate in |
| A. | 100 microsecond |
| B. | 50 millisecond |
| C. | 0.5 sec |
| D. | 0.1 sec |
| Answer» B. 50 millisecond | |
| 83. |
Overfluxing protection is recommended for |
| A. | distribution transformer |
| B. | generator transformer of the power plant |
| C. | auto-transformer of the power plant |
| D. | station tr |
| Answer» A. distribution transformer | |
| 84. |
Series capacitors are used to |
| A. | compensate for line inductive reactance |
| B. | compensate for line capacitive reactance |
| C. | improve line voltage |
| D. | none of the above |
| Answer» A. compensate for line inductive reactance | |
| 85. |
Admittance relay is _______ relay. |
| A. | impedance |
| B. | directional |
| C. | non-directional |
| D. | none of the above |
| Answer» B. directional | |
| 86. |
The material used for fuse must have |
| A. | low melting point and high specific resistance |
| B. | low melting point and -low specific resistance |
| C. | high melting point and low specific resistance |
| D. | low melting point and any specific resistance |
| Answer» A. low melting point and high specific resistance | |
| 87. |
If the fault occurs near the impedance relay, the VII ratio will be |
| A. | constant for all distances |
| B. | lower than that of if fault occurs away from the relay |
| C. | higher than that of if fault occurs away from the relay |
| D. | none of the above |
| Answer» B. lower than that of if fault occurs away from the relay | |
| 88. |
The torque produced in induction type relay (shaded pole structure) is |
| A. | inversely proportional to the current |
| B. | inversely proportional to the square of the current |
| C. | proportional to the current |
| D. | proportional to square of the current |
| Answer» B. inversely proportional to the square of the current | |
| 89. |
The steady state stability of the power system can be increased by |
| A. | connecting lines in parallel |
| B. | connecting lines in series |
| C. | using machines of high impedance |
| D. | reducing the excitation of machines |
| Answer» A. connecting lines in parallel | |
| 90. |
The inductive interference between power and communication line can be minimized by |
| A. | transposition of the power line |
| B. | transposition of the communication line |
| C. | both (a) and (b) |
| D. | increasing the distance between the conductors |
| Answer» C. both (a) and (b) | |
| 91. |
The power loss is an important factor for the design of |
| A. | transmission line |
| B. | motor |
| C. | generator |
| D. | feeder |
| Answer» A. transmission line | |
| 92. |
A fuse is connected |
| A. | in series with circuit |
| B. | in parallel with circuit |
| C. | either in series or in parallel with circuit |
| D. | none of the above |
| Answer» A. in series with circuit | |
| 93. |
H.R.C. fuse, as compared to a rewirable fuse, has |
| A. | no ageing effect |
| B. | high speed of operation |
| C. | high rupturing capacity |
| D. | all of the above |
| Answer» D. all of the above | |
| 94. |
The fuse rating is expressed in terms of |
| A. | current |
| B. | voltage |
| C. | VAR |
| D. | kVA |
| Answer» A. current | |
| 95. |
The fuse blows off by |
| A. | burning |
| B. | arcing |
| C. | melting |
| D. | none of the above |
| Answer» C. melting | |
| 96. |
On which of the following effects of electric current a fuse operates ? |
| A. | Photoelectric effect |
| B. | Electrostatic effect |
| C. | Heating effect |
| D. | Magnetic effect |
| Answer» C. Heating effect | |
| 97. |
An isolator is installed |
| A. | to operate the relay of circuit breaker |
| B. | as a substitute for circuit breaker |
| C. | always independent of the position of circuit breaker |
| D. | generally on both sides of a circuit breaker |
| Answer» D. generally on both sides of a circuit breaker | |
| 98. |
A fuse in a motor circuit provides protection against |
| A. | overload |
| B. | short-circuit and overload |
| C. | open circuit, short-circuit and overload |
| D. | none of the above |
| Answer» B. short-circuit and overload | |
| 99. |
Protection by fuses is generally not used beyond |
| A. | 20 A |
| B. | 50 A |
| C. | 100 A |
| D. | 200 A |
| Answer» C. 100 A | |
| 100. |
A fuse is never inserted in |
| A. | neutral wire |
| B. | negative of D.C. circuit |
| C. | positive of D.C. circuit |
| D. | phase dine |
| Answer» A. neutral wire | |
Done Studing? Take A Test.
Great job completing your study session! Now it's time to put your knowledge to the test. Challenge yourself, see how much you've learned, and identify areas for improvement. Don’t worry, this is all part of the journey to mastery. Ready for the next step? Take a quiz to solidify what you've just studied.