In Biot number, the characteristic length used is the ratio of the __________ of the solid.

Related MCQs

• 200 kg of solids (on dry basis) is subjected to a drying process for a period of 5000 seconds. The drying occurs in the constant rate period with the drying rate as, Nc = 0.5 × 10-3 kg/m2 .s. The initial moisture content of the solid is 0.2 kg moisture/kg dry solid. The interfacial area available for drying is 4 m2 /1000 kg of dry solid. The moisture content at the end of the drying period is (in kg moisture/kg dry solid).
• A metal wire of 0.01 m dia and thermal conductivity 200 W/m.K is exposed to a fluid stream with a convective heat transfer coefficient of 100 W/m2 .K. The Biot number is
• In which mode of heat transfer, the Biot number is important?
• The coefficient of linear expansion of a solid is L. The volume V of a cube of this solid on being heated by 1?C will change by
• The rate of heat flow between a solid wall and a fluid (in contact with a solid wall) is given by
• Three solid objects of the same material and of equal mass-a sphere, a cylinder (length = diameter) and a cube are at 500°C initially. These are dropped in a quenching bath containing a large volume of cooling oil each attaining the bath temperature eventually. The time required for 90% change in temperature is the smallest for
• If the temperature of a solid surface changes form 27°C to 627°C, then its emissive power changes in the ratio of
• When the ratio of the Grashoff number and to the square of Reynolds number is one, the dominant mechanism of heat transfer is:
• Two rods one of copper and the other of mild steel, both of diameter 20 mm and length 250 mm are coated with a uniform layer of wax all around. These rods are placed vertically in a boiling water bath with 200 mm, length of each rod projecting outside. If the melting point of wax is 10?C, then
• In a laboratory test run, the rate of drying was found to be 0.5 x 10-3 kg/m2 .s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2 /kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is