The angular play bearing must be mounted without axial play.

Related MCQs

• Angular contact bearing can take thrust as well as radial loads.
• Cylindrical load bearing has lower load capacity as compared to deep groove ball bearing.
• Bearing modulus is the bearing characteristic number at
• The bearing characteristic number shown in the graph is directly proportional to the unit bearing pressure.
• Miter gears are the bevel gears mounted on shaft which are intersecting at angle greater than 90.
• In angular contact bearings,          bearings are required to take thrust load in both directions.
• The safe stress for a hollow steel column which carries an axial load of 2100 kN is 125 MN/m2. if the external diameter of the column is 30cm, what will be the internal diameter?
• Calculate the diameter of pin from shear consideration with maximum shear stress allowed is 40NN/mm² and an axial tensile force of 50kN is acting on the rod.
• Pitch of coil is defined as axial distance in compressed state of the coil.
• If knuckle joint is to fail by crushing failure of pin in fork, then determine the diameter of knuckle pin when 50kN axial tensile force act on rods. Given: Max allowable compressive stress=25N/mm², thickness of each eye of fork=25mm.