McqMate

Q. |
## The binary numbers A = 1100 and B = 1001 are applied to the inputs of a comparator. What are the output levels? |

A. | a > b = 1, a < b = 0, a < b = 1 |

B. | a > b = 0, a < b = 1, a = b = 0 |

C. | a > b = 1, a < b = 0, a = b = 0 |

D. | a > b = 0, a < b = 1, a = b = 1 |

Answer» C. a > b = 1, a < b = 0, a = b = 0 |

3.2k

0

Do you find this helpful?

20

View all MCQs in

Digital Electronics and Logic DesignNo comments yet

- A certain BCD-to-decimal decoder has active-HIGH inputs and active- LOW outputs. Which output goes LOW when the inputs are 1001?
- Two 4-bit comparators are cascaded to form an 8-bit comparator. The cascading inputs of the most significant 4 bits should be connected .
- How many 4-bit parallel adders would be required to add two binary numbers each representing decimal numbers up through 30010?
- The Unsigned Binary representation can only represent positive binary numbers
- For the device shown here, let all D inputs be LOW, both S inputs be HIGH, and the input be LOW. What is the status of the Y output?
- A J-K flip-flop has two control inputs. What happens to the Q output on the active edge of the clock if both control inputs are asserted simultaneously?
- 9: Consider an RS lip-lops with both inputs set to 0. If a momentary '1' is applied at the input S,then the output
- Consider an up/down counter that counts between 0 and 15, if external input(X) is “0” the counter counts upward (0000 to 1111) and if external input (X) is “1” the counter counts downward (1111 to 0000), now suppose that the present state is “1100” and X=1, the next state of the counter will be
- What is the largest number of data inputs which a data selector with two control inputs can have ?
- What is the largest number of data inputs which a data selector with two control inputs can have ?