Which of the following operation causes residual compressive stress on the surface of the material?

Related MCQs

• In a gas turbine rotor a radial stress of 300 kg/sq cm tensile and 500 kg/sq cm tangential stress have been found at a point. The maximum shear stress at this point would be
• With a punch for which the maximum crushing stress is 4 times the maximum shearing stress of the plate, the biggest hole that can be punched in the plate would be of diameter equal to
• Which of the following theory is also known as maximum shear stress theory of the failure of a material at the elastic limit
• In case of biaxial stress system when a member is subjected to tensile stresses in two perpendicular directions the maximum shear stress in case of mild steel occurs on a plane inclined at
• The ratio of maximum shear stress to average shear stress for a circular section is
• If the shearing stress in a nut is equal to half the tensile stress in a bolt then the length of nut should be equal to
• Operation of helical gears is silent and quiet while the operation of the spur gears is noisy because
• A block weighing 1000 kg rests on a horizontal surface. The coefficient of friction is 0.3 (both static and kinetic). What frictional force will be developed if the force applied to the block in the direction parallel to the horizontal surface is 40 kg
• In case of a cotter joint the compressive load is transmitted from one rod to another rod
• A thin cylinder contains fluid at a pressure of 30 kg kg/cm2, the internal diameter of the shell is 60 cm and the tensile stress in the material is to be limited to 900 kg/cm2. The shell must have a minimum wall thickness of