Structural members subjected to bending and large axial compressive loads are known as

Related MCQs

• Calculate minimum wall thickness given a cylindrical prestressed water tank of internal diameter 30m over a depth of 7.5m and the permissible compressive stress at transfer is 13n/mm2 and the maximum compressive stress under working pressure is 1n/mm2 and the loss ratio is 0.75?
• Which of the following is economical if depth is limited and loads are too large?
• Members used to carry wall loads over wall openings are called
• Calculate the spacing of 5mm wires having a loss ratio of 0.075, compressive stress is 10.75n/mm2, 5mm diameter wires stress is 1000n/mm2, 12 wires of 8mm diameter are stressed to 1200n/mm2(Nd = 840n/mm2)?
• Which of the following loads are not considered in the design of gantry girders?
• The architect is usually the lead designer on buildings, with a structural engineer employed as a sub-consultant.
• Simple bending takes place if
• Bending resistance of plate girders can be increased by
• The bending moment due to dead load of girder is maximum at
• In the case of large tanks, the base slabs is subdivided by