Minimum compressive strength in N/mm² for H1 type mortar used for masonry is

Related MCQs

• For masonry built in 1 : 1 : 6 cement-lime-sand mix mortar or equivalent, the horizontal shear stress permissible on the area of a mortar bed joint is
• For masonry work with solid bricks, consistency of mortar should be
• For earthquake resistant masonry buildings, the vertical distance between openings one above the other in a load bearing wall shall not be less than
• The mode of failure of a very short masonry member having h/t ratio of less than 4 is by
• The basic stress in masonry units having height to width ratio of 1.5 may be increased by a factor of
• The timber floor not spanning on the masonry wall but properly anchored to the wall gives
• For designing masonry components of a structure, seismic forces provision in the design calculation is not necessary for buildings constructed in
• Water retentivity for brick masonry should not be less than
• Direct load carrying capacity of a brick masonry wall standing freely as against when it supports RC slab will be
• Minimum thickness of stiffening wall for 1 to 3 storeys shall not be less than