A full wave rectifier with resistive load produces

Related MCQs

• A single phase half wave rectifier is feeding a resistive load. When a = 0, dc output voltage is 127 V. When a = 30°, the dc output voltage will be about
• In a single phase full wave regulator feeding a resistive load, the average current over one full cycle
• A single phase half wave converter is feeding a resistive load. Just before triggering, the voltage across thyristor is
• In a single phase full wave rectifier, during blocking state the peak inverse voltage of diode is
• In a full wave rectifier, the rectification ratio is approximately equal to
• A single phase half wave controlled rectifier circuit has an R-L load. A freewheeling diode is also in the circuit. When freewheeling diode is conducting the SCR
• In a full wave converter (M - 2 connection) feeding an RLE load, the peak thyristor current is 15 A. For fully controlled bridge circuit and same load current, the peak thyristor current will be
• A single phase voltage controller has input of 230 V and a load of 15 Ω resistive. For 6 cycles on and 4 cycles off, determine the average value of SCR current.
• In a fully controlled bridge converter feeding a resistive load the waveshapes of output voltage and output current
• In a 3 phase half wave rectifier, when firing angle is less than 90 degree, then the average dc output voltage becomes