A simple supported steel beam when loaded with a force of 100 kg at A is found to deflect 10 mm at B. What force at B would cause a deflection of 2.5 mm at A

Related MCQs

• A cantilever beam of square section is subjected to a load W at the free end. If the length of the beam is increased and load reduced to half the deflection at the free end as compared to original deflection would be
• A solid shaft of 100 mm diameter transmits 100 HP at (450/?) r.p.m. The torque in kg-m on the shaft would be
• The ratio of the plastic moment capacity to the yield moment capacity of a rolled steel beam section is about
• The deflection of a helical spring is
• If machine number is loaded in such a way that the three principla stresses at a point are 600 kg/cm2 compression. 800 kg/cm2 tension and zero. The maximum shear stress at the point will be
• If a machine member is loaded in such a way that the three principal stresses at a point are 600 kg/cm2 tension, 800 kg/cm2 compression and zero. The maximum shear stress at the point will be
• As far as possible adhesive joints should be loaded in
• A spherical gas tank is made of 1 cm steel plate hemispheres but welded together. The tank is 1503 cm in diameter. The allowable internal pressure to which tank may be subjected is the permissible stress be limited to 840 kg/sq cm would be in the range
• In case of rolled steel beams, the chear force is resisted by
• In a gas turbine rotor a radial stress of 300 kg/sq cm tensile and 500 kg/sq cm tangential stress have been found at a point. The maximum shear stress at this point would be