The heaviest I-section for same depth is

Related Questions

• When the depth of a plate girder is at least times the depth of vertical leg of the flange angles, the girder is known as deep plate girder, if is
• When the depth of a plate girder is at least times the depth of vertical leg of the flange angles, the girder is known as deep plate girder, if is
• If the depth of two column sections is equal, then the column splice is provided
• The economical depth d of a web plate in which allowable bearing stress is fb, and the maximum bending moment is M, as suggested by Rawater and Clark, is
• If is the maximum allowable bending stress in a tension member whose radius of gyration is and depth is 2y, the required cross sectional area is given by
• Economical depth of a plate girder corresponds to
• Under a concentrated load, bearing stress fb in a beam is given by (where b is the length of the bearing plate and h is the depth of the root of the fillet).
• A web plate is called unstiffened if the ratio of clear depth to thickness is less than
• If the depth of the section of an upper column is smaller than the lower column
• In case of cantilever fillers, the ratio of the span L to depth d, should not exceed