[Solved] Slenderness ratio of a compression member is

McqMate

Q.	Slenderness ratio of a compression member is
A.	moment of inertia/radius of gyration
B.	effective length/area of cross-section
C.	radius of gyration/effective length
D.	radius of gyration/ area of cross-section
Answer» C. radius of gyration/effective length

702

0

Do you find this helpful?

3

View all MCQs in

Design of Steel Structures

Discussion

No comments yet

Related MCQs

The maximum slenderness ratio of a compression member carrying both dead and superimposed load is
The maximum permissible slenderness ratio of compression member carrying dead and superimposed load, is
Compression members composed of two channels back-to-back and separated by a small distance are connected together by riveting so that the minimum slenderness ratio of each member between the connections, does not exceed
The maximum slenderness ratio of a compression member carrying both dead and superimposed load is
The maximum permissible slenderness ratio of compression member carrying dead and superimposed load, is
A tension member, if subjected to possible reversal of stress due to wind, the slenderness ratio of the member should not exceed
A tension member, if subjected to possible reversal of stress due to wind, the slenderness ratio of the member should not exceed
Secant formula for direct stress in compression, is applicable only for slenderness ratio upto
Secant formula for direct stress in compression, is applicable only for slenderness ratio upto
For a steel member of slenderness ratio 350, the allowable stress is 76 kg/cm2 if it is