- Civil Engineering
- Design of Steel Structures
- The gross diameter of a rivet is the dia...

Q. |
## The gross diameter of a rivet is the diameter of |

A. | cold rivet before driving |

B. | rivet after driving |

C. | rivet hole |

D. | none of these |

Answer» B. rivet after driving |

View all MCQs in:
Design of Steel Structures

- The distance measured along one rivet line from the centre of a rivet to the centre of adjoining rivet on an adjacent parallel rivet line, is called
- The distance measured along one rivet line from the centre of a rivet to the centre of adjoining rivet on an adjacent parallel rivet line, is called
- When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which moment in any rivet.)
- Diameter of a rivet hole is made larger than the diameter of the rivet by
- In a truss girder of a bridge, a diagonal consists of mild steel flat 4001.S.F. and carries a pull of 80 tonnes. If the gross-diameter of the rivet is 26 mm, the number of rivets required in the splice, is
- In a truss girder of a bridge, a diagonal consists of mild steel flat 4001.S.F. and carries a pull of 80 tonnes. If the gross-diameter of the rivet is 26 mm, the number of rivets required in the splice, is
- Minimum pitch of the rivets shall not be less than (Where d is gross diameter of rivet)
- If the thickness of plate to be connected by a rivet is 16 mm, then suitable size of rivet as per Unwin's formula will be
- If the thickness of plate to be connected by a rivet is 16 mm, then suitable size of rivet as per Unwin's formula will be
- The difference between gross diameter and nominal diameter for the rivets up to 25 mm diameter is

Login to Continue

It will take less than 2 minutes

Report MCQ