Elongation of a bar of uniform cross section of length „L‟, due to its own weight „W‟ is given by

Related MCQs

• steel bar 10 mm x 10 mm cross section is subjected to an axial tensile load of 20kN. If the length of bar is 1 m and E = 200 GPa, then elongation of the bar is:
• An axial pull of 50 KN is suddenly applied to a steel bar 2 m long and 1000 mm2 in cross-section. If modulus of elasticity is 200 GPa, find strain energy stored in the bar
• The length of a column, having a uniform circular cross-section of 7.5 cm diameter and whose ends are hinged, is 5 m. If the value of E for the material is 2100 kN/cm2, the permissible maximum crippling load will be
• 3.5 m long bar is under tensile load and due to that increase in length of bar is 1.75 mm then strain =
• During a tensile test on a specimen of 1 cm cross-section, maximum load observed was 8 tonnes and area of cross-section at neck was 0.5 cm2. Ultimate tensile strength of specimen is
• The increase in the length of a bar of length 1 m, area 300 mm2, modulus of elasticity 2×10^5 N/mm2 due to a tensile load of 120 KN is .
• Columns of given length, cross-section and material have different values of buckling loads for different end conditions. The strongest column is one whose
• A bar 2 m long and 20 mm diameter is subjected to an axial pull of 125.6 KN. Due to this load, length increases by 4 mm and diameter reduce by 0.012 mm. Find Poison‟s ratio.
• The ratio of the effective length of a column and minimum radius of gyration of its cross-sectional area, is known
• The slenderness ratio of a vertical column of square cross- section of 10 cm side and 500 cm long, is