

McqMate
These multiple-choice questions (MCQs) are designed to enhance your knowledge and understanding in the following areas: Civil Engineering .
501. |
A good brick earth should contain |
A. | about 20% to 30% of alumina |
B. | about 50% to 60% of silica |
C. | not more than 5% of lime |
D. | All the above. |
Answer» D. All the above. |
502. |
The commonly used lime in white washing, is |
A. | white lime |
B. | fat lime |
C. | hydraulic lime |
D. | lime |
Answer» B. fat lime |
503. |
Pick up the plutonic rock from the following |
A. | Granite |
B. | Dolerite |
C. | Basalt |
D. | All the above. |
Answer» A. Granite |
504. |
Seasoning is |
A. | a process of removing sap |
B. | creosoting |
C. | painting with sodium silicate |
D. | Coating with tar. |
Answer» A. a process of removing sap |
505. |
Rocks formed due to alteration of original structure due to heat and excessive pressure are |
A. | sedimentary rocks |
B. | igneous rocks |
C. | metamorphic rocks |
D. | none of these. |
Answer» C. metamorphic rocks |
506. |
The compound of Portland cement which contributes strength after two to three years is |
A. | Tricalcium silicate |
B. | Di-calcium silicate |
C. | Tricalcium aluminate |
D. | Tetra calcium alumina ferrite. |
Answer» B. Di-calcium silicate |
507. |
For slaking of 10 kg of CaO, the theoretical amount of water is |
A. | 2.2 kg |
B. | 1.5 kg |
C. | 3.2 kg |
D. | None of these. |
Answer» C. 3.2 kg |
508. |
Bessemer process is used for the manufacture of |
A. | Pig iron |
B. | cast iron |
C. | Wrought iron |
D. | Steel. |
Answer» D. Steel. |
509. |
The portion of the brick without a triangular corner equal to half the width and half the length, is called |
A. | closer |
B. | queen closer |
C. | king closer |
D. | Squint brick. |
Answer» C. king closer |
510. |
The standard size of masonry bricks, is |
A. | 18 cm x 8 cm x 8 cm |
B. | 19 cm x 9 cm x 9 cm |
C. | 20 cm x 10 cm x 10 cm |
D. | 21 cm x 11 cm x 11 cm |
Answer» B. 19 cm x 9 cm x 9 cm |
511. |
A good quality stone absorbs water less than |
A. | 5% |
B. | 10% |
C. | 15% |
D. | 20% |
Answer» A. 5% |
512. |
Plywood is made from |
A. | common timber |
B. | bamboo fibre |
C. | teak wood only |
D. | all of above |
Answer» C. teak wood only |
513. |
If the iron ore contains clay as an impurity, the flux added during calcination, is |
A. | clay |
B. | lime stone |
C. | argillaceous iron ore |
D. | all the above. |
Answer» B. lime stone |
514. |
Cast steel is manufactured by |
A. | Cementation process |
B. | Crucible process |
C. | Bessemer process |
D. | Open hearth process. |
Answer» B. Crucible process |
515. |
1st class brick immersed in water for 24 hours, should not absorb water (by weight) more |
A. | 10% |
B. | 15% |
C. | 20% |
D. | 25% |
Answer» C. 20% |
516. |
Geologically, marble is known as |
A. | sedimentary rock |
B. | igneous rock |
C. | metamorphic rock |
D. | Stratified rock. |
Answer» C. metamorphic rock |
517. |
The commonly used drying oil for oil paints, is |
A. | olive oil |
B. | linseed oil |
C. | kerosene oil |
D. | accetate of lead. |
Answer» D. accetate of lead. |
518. |
The foliated structure is very common in |
A. | sedimentary rocks |
B. | igneous rocks |
C. | metamorphic rocks |
D. | none of these. |
Answer» C. metamorphic rocks |
519. |
Turpentine oil is used in paints as |
A. | thinner |
B. | vehicle |
C. | base |
D. | drier. |
Answer» A. thinner |
520. |
The hardest rock is |
A. | marble |
B. | diamond |
C. | talc |
D. | Quartz. |
Answer» B. diamond |
521. |
The silica is used for preparing |
A. | silica bricks |
B. | coke oven |
C. | lining for glass furnaces |
D. | All of these. |
Answer» D. All of these. |
522. |
Fibre boards can be |
A. | distempered |
B. | painted |
C. | painted and distempered |
D. | Used for furniture. |
Answer» D. Used for furniture. |
523. |
Pick up the correct statement from the following |
A. | Catalysts are added to assist and accelerate the hardening of resin, |
B. | The fillers are inert materials and they impart strength and hardness |
C. | Fibrous fillers increase thermal resistance |
D. | All the above. |
Answer» D. All the above. |
524. |
Formula for quick lime, is |
A. | CaCO3 |
B. | CaO |
C. | CO3CO2 |
D. | None to these. |
Answer» B. CaO |
525. |
For the manufacture of stainless steel, steel is mixed with |
A. | chromium |
B. | nickel |
C. | tungsten |
D. | None of these. |
Answer» A. chromium |
526. |
Stones used for ornamental work must be |
A. | soft |
B. | hard |
C. | light |
D. | heavy. |
Answer» A. soft |
527. |
The operation of removal of impurities or clay adhering to iron ores, is known as |
A. | dressing |
B. | calcination |
C. | roasting |
D. | smelting. |
Answer» A. dressing |
528. |
If water required for 1 bag of cement is 30 liters, the water cement ratio is |
A. | 0.40 |
B. | 0.50 |
C. | 0.60 |
D. | None of these. |
Answer» C. 0.60 |
529. |
Portland cement manufactured from pure white chalk and clay, free from iron-oxide, known as |
A. | quick setting cement |
B. | rapid hardening cement |
C. | white cement |
D. | low heat Portland cement. |
Answer» C. white cement |
530. |
Dry rot |
A. | cracks the timber |
B. | reduces the strength of timber |
C. | reduces the timber to powder |
D. | shrinks the timber |
Answer» C. reduces the timber to powder |
531. |
Which one of the following polymers is obtained from condensation polymerization ? |
A. | phenol formaldehyde |
B. | carbamide |
C. | melamine-formaldehyde |
D. | all of these. |
Answer» D. all of these. |
532. |
The weight of 1 m3 of brick earth, is about |
A. | 1200 kg |
B. | 1500 kg |
C. | 1800 kg |
D. | 2000 kg. |
Answer» C. 1800 kg |
533. |
Pozzolana (or surkhi) is used in lime |
A. | to impart hydraulicity |
B. | to prevent shrinkage |
C. | to decrease the cost of construction |
D. | to decrease the setting time. |
Answer» A. to impart hydraulicity |
534. |
Mastic asphalt is normally used for |
A. | sound insulation |
B. | water proofing |
C. | fire proofing |
D. | none to these. |
Answer» B. water proofing |
535. |
Lime stone is not a |
A. | sedimentary rock |
B. | stratified rock |
C. | aqueous rock |
D. | metamorphic rock. |
Answer» D. metamorphic rock. |
536. |
A piece of timber whose thickness and width are respectively 5 cm and 10 cm is called |
A. | slate |
B. | plank |
C. | board |
D. | Strip. |
Answer» D. Strip. |
537. |
Pig iron is manufactured from the ores by |
A. | dressing |
B. | calcination and roasting |
C. | smelting |
D. | all the above. |
Answer» D. all the above. |
538. |
The maximum permissible colour for domestic supplies based on cobalt scale, is |
A. | 5 ppm |
B. | 10 ppm |
C. | 15 ppm |
D. | 20 ppm |
Answer» D. 20 ppm |
539. |
The portion of a brick cut to form angles other than right angles in plan, is known as |
A. | queen closer |
B. | king closer |
C. | closer |
D. | squint brick. |
Answer» D. squint brick. |
540. |
Plywood is obtained by gluing wooden sheets at |
A. | 100 to 150 N/cm2 |
B. | 100 to 130°C |
C. | both (a) and (b) |
D. | Neither (a) nor (b). |
Answer» C. both (a) and (b) |
541. |
The low voltage porcelain is mainly used for |
A. | switch block |
B. | insulating tubes |
C. | lamp sockets |
D. | All of these. |
Answer» D. All of these. |
542. |
Putty is |
A. | made with finely powdered chalk and linseed oil |
B. | used for fixing glass panes |
C. | softened by a solution of pearl ash and quick-lime soaked in water |
D. | all the above. |
Answer» D. all the above. |
543. |
PVC stands for |
A. | plastic very compact |
B. | polythene vinyl chloride |
C. | polythene vinyl carbon |
D. | polythene vanadium carbide. |
Answer» B. polythene vinyl chloride |
544. |
Generally wooden mounds are made from |
A. | ply wood |
B. | shisham wood |
C. | deodar wood |
D. | teak wood |
Answer» B. shisham wood |
545. |
The cement becomes unsound by the presence of excess |
A. | sulphur |
B. | magnesia |
C. | lime |
D. | All of these. |
Answer» D. All of these. |
546. |
A volatile substance added to a paint to make its application easy and smooth, is known as |
A. | base |
B. | solvent |
C. | vehicle |
D. | none to these. |
Answer» B. solvent |
547. |
The main ingredient of a good quality brick earth, is |
A. | magnesia |
B. | lime |
C. | silica |
D. | Alumina. |
Answer» D. Alumina. |
548. |
Bitumen is generally obtained from |
A. | organic material |
B. | synthetic material |
C. | petroleum product |
D. | coal. |
Answer» C. petroleum product |
549. |
The steel which contains fissures and cavities, is manufactured by |
A. | Cementation process |
B. | Crucible process |
C. | Bessemer process |
D. | Open hearth process. |
Answer» A. Cementation process |
550. |
Pick up the volcanic rock from the following |
A. | Granite |
B. | Dolerite |
C. | Basalt |
D. | All the above. |
Answer» C. Basalt |
Done Studing? Take A Test.
Great job completing your study session! Now it's time to put your knowledge to the test. Challenge yourself, see how much you've learned, and identify areas for improvement. Don’t worry, this is all part of the journey to mastery. Ready for the next step? Take a quiz to solidify what you've just studied.